ElectrIQ AIRCUBE Manual do Utilizador descarregar pdf (Página 8)

Page 8 of 13

Press the icon to select your desired operating times.

Use the TIMER button to adjust hours

You can only set the auto-shut off timer while the unit is operating (on)

You can only set the auto-start timer while the unit is in standby (off)

You can set the function and fan speed while setting the timer.

Pressing the POWER key before count down turns the unit on or off will clear

the settings

SLEEP button

While in cooling mode, press the SLEEP to enter SLEEP mode. It will

increases the setting with 1°C after an hour and readjust to a 2°C increase

after 2 hours.

While in heating mode, press the SLEEP to enter SLEEP mode. It will

decreases the setting with 1°C after an hour and readjust to a 2°C increase

after 2 hours.

LED DISPLAY The display indicates the current ambient temperature or the

timer setting. When the set temperature or the timer is adjusted, the new setting

is shown then the display returns the current set temperature.

The display is also used to show error codes should a fault occur, see ERROR CODES

ALARM When the water tank is full, E4 will be displayed on the LED panel.

To resume operation, please remove the rubber cap of the drain hose and

empty the tank. The E4 warning will disappear after draining, and the unit can

be restarted by pressing the POWER key.

2. Remote control

Drawing of Remote Control

On/Off

Function selection

Stopping time

Automatic fan speed

High fan speed

Medium fan speed

Low fan speed

Sleep selection

Temperature selection

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

ElectrIQ AIRCUBE Manual do Utilizador Página 8